One orthodontist. One lab. Every aligner made under one roof.

I started this project for two reasons: patients deserve aligners planned by a specialist, and dentists deserve clear, practical knowledge about aligners from someone who works with them every day.

The Aligner Project by Dr. RizwinUpdated

Part 1: the lab

From scan to aligner, without leaving the building.

Most aligners are made in a factory far away. Mine are made down the corridor, so I check every set myself and refinements come back fast.

  1. Scan

    A 3D digital model of your teeth

  2. Plan

    Every movement designed by me

  3. Print

    A model for each stage

  4. Form & trim

    Clear trays shaped and polished

  5. Checked & sent

    Fit verified, then delivered

Fig. 1 · Inside my aligner unit

Sheet clamped in the frame

3D render of an aligner pressure former: a heater, a clamp ring holding a clear sheet and a 3D-printed dental model under it
An aligner pressure former in my in-house unit: the heater softens a clear 0.75 mm sheet, the frame lowers it over a 3D-printed model of your teeth, and pressure holds it tight while it cools. Illustration.

Part 2: educating dentists

Helping fellow dentists understand aligners better.

How aligners work, the materials behind them, which cases suit them, and what makes treatment succeed, shared through real experience from my practice and in-house unit.

In person

Talks & lectures

At study clubs, dental colleges and conferences.

Online

Education sessions

Online sessions on aligner fundamentals, materials and patient selection.

Every week

Knowledge sharing

Case discussions, research insights and short videos on what makes aligners work.

Dentist or clinic? Let’s talk.

Invite me for a talk, or join an aligner education session.

Book consultation